
						  CuSeeMe/2 Support
						  =================

General:
--------

There are three PlugIn modules for CuSeeMe/2, all of which support B&W
and Colour cameras.

1) QV2CUCME.DLL - An Interface between QV2 and CuSeeMe/2.

This requires the QuickCam Viewer, QV2, which must be running to feed
the picture it is currently displaying to the interface. CuSeeMe/2
fetches this picture from the Interface. The advantage is that the
full flexibility of QV2 can be used to size the picture and adjust
camera settings. There is no camera control via the CuSeeMe/2 Local
Video Setup dialog.

2) QVCUSOLO.DLL - A StandAlone plugin which only requires the supplied
device-driver and support DLLs to be available.

This has the advantage that it does nothing until CuSeeMe/2 requests
a picture. The CuSeeMe/2 Setup dialog on the Local Video window
provides support for adjusting camera controls. Where a colour camera
is detected a thumbnail picture is displayed in colour to enable
camera settings to be set accurately.

3) QVCUGREY.DLL - A StandAlone plugin which only requires the supplied
device-driver and support DLLs to be available.

This is identical to QVCUSOLO.DLL with the exception that it always
transmits Greyscale images when a Colour camera is connected.


Installation:
-------------

Note that the installation routine for the QuickCam Viewer, QV2, must
be run to install the device-driver and set appropriate CONFIG.SYS
entries. A reboot will be required to make the changes effective.

Installing the PlugIns for use with CuSeeMe/2 is performed using the
CuSeeMe/2 PlugIn Centre.


Notes:
------

The low-light filter is automatically enabled when the brightness
reaches a value of 160 and cannot be disabled.

