Release memo for STL2 BMC Firmware Version 01.19, 11.19 and PIA Update.

1. Release data

    - STL2FWPIA1. zip is the data to update latest BMC Firmware and PIA
      for Tupelo which has 1LED-type front panel. Version is 11.19.

    - STL2FWPIA2. zip is the data to update latest BMC Firmware and PIA
      for Tupelo which has 2LED-type front panel. Version is 01.19

2. Changes between STL2 BMC Firmware version 01.17 and version 01.19
  - Modified DR13059 and DR13063 issue.

    *)The difference of version 01.19 and 11.19 is only the string of the
      version for distinguish the PIA difference.

3. Upgrade Instructions
3.1 Creating a Bootable Floppy
    You must use a DOS system to create the bootable floppy.
    1)Place an unformatted floppy diskette in the floppy drive and format
      the floppy using the /S option. example: "format a: /s"
    2)Alternatively, place a formatted floppy in the floppy drive and use
      the "sys" command. example: "sys a:"
    3)Place a ANSI.sys file in the root directory.
      example: "C:\> copy DOS\ANSI.sys a:\"

3.2 Making a  Upgrade Floppy
    1)Follow the instructions (above) for creating a bootable floppy to
      create a bootable floppy diskette.
    2)Insert the bootable floppy into drive a:.
    3)Extract the contents of the ZIP file onto the bootable floppy.

3.3 Upgrading
    1)Place the bootable floppy containing the Firmware and PIA into drive
      a: of the system that you want to upgrade and boot the system while
      the floppy diskette is in the drive.
    2)Current firmware information is displayed. Enter the ESC key.
    3)Firmware update menu is displayed. Select the "Update Firmware".
    4)The following message is displayed. Select the "Excute".

      Are you sure that you want to update the firmware?

    5)This update processing takes few minutes.  Never turn off the system
      during the update processing. The following message appears when the
      update processing is finished. Enter the any key.
 
      Entering any key, DC is turned off.
      Please turn DC on, after wait a few seconds.
    
    6)You can confirm whether update was done successfully or not, by the messages
     in BIOS bootstrap:

        Base Board Management Controller
                :                          :
        IPMI Version    :1.0     Firmware version :01.19

       Check the Firmware Version written.

