                            
08/18/93

This diskette contains a Beta version of the Tseng Labs ET4000/W32 and 
ET4000/W32i display driver for OS/2 2.1.  This driver is provided expressly
for derive feedback from selected Beta sites.  Any use of this driver is 
strictly confidential. This diskette and/or any files it contains may not 
be made available to others without the prior written consent of Tseng 
Labs, Inc.  

Tseng Labs appreciates your support. As with any Beta test software, users 
can reasonably expect to experience problems. Should problems occur that are 
not listed below, you should contact Tseng Labs with the step-by-step process 
to assist Tseng in re-creating the problem. Tseng Labs can be contacted 
electronically through CompuServe EMAIL at 71333,430, at 532-3058@MCIMAIL.COM
for users of Internet, or through our native BBS at (215) 579-7536. Problem
reports may not be submitted through public CompuServe Forums or other public
forums.

                            KNOWN PROBLEMS

The installation of the driver is somewhat clumsy, requiring some user
interaction at the OS/2 command prompt.  This is partially due to 
recommended OS/2 Display Installation procedure, as well as, the fact that
this is a Beta driver.  The final release of the driver will provide a 
better installation method.  Please follow the installation instructions
below.  You may also reference the OS/2 Version 2.1 Installation guide 
p. 114.

NOTE:  The Installation Diskette Volume Label must be TSENG 1.  Please
use the Diskcopy utility if a backup diskette is made.
                            
                            
                        INSTALLATION  INSTRUCTIONS


1.      Open OS/2 SYSTEM.
2.      Open COMMAND PROMPTS.
3.      Open either OS/2 WINDOW or OS/2 FULL SCREEN.
4.      Insert Tseng Installation diskette in drive A.
5.      Type:

                CD \OS2\INSTALL [enter]
                COPY A:\TSENGW32.DSC [enter]
                DSPINSTL [enter]

6.      From the DISPLAY DRIVER INSTALL window,
                select PRIMARY DISPLAY
                select OK.

7.      From the PRIMARY DISPLAY ADAPTER TYPE window,
                select TSENG LABORATORIES ET4000/W32i
                select OK.

8.      From the MONITOR CONFIGURATION/SELECTION UTILITY window,
                select INSTALL USING DEFAULTS FOR MONITOR TYPE
                select OK.

9.      From the SELECT DISPLAY RESOLUTION window,
                select the desired resolution
                select OK.

10.     From the SOURCE DIRECTORY window,
                select INSTALL.

11.     When the drivers are completely installed, you will be prompted 
         to shut down and restart the system for changes to take effect.
                select OK.

12.     Remove the diskette from drive A.
13.     Shut down and restart.

     
