
        Installing the WIND/X Display Driver for GEM

     In order to install this graphics driver for GEM:

NOTE: This driver only works in the 1024x768 mode.More 
      drivers will be available as they are released.
      
     1) Install GEM as described in the doucumentation
     included with the software.  If GEM is already
     installed on your system, go to Step 2.

     2) Go to the subdirectory where GEM is installed.

          Example:  C:\> cd\gemapps\gemsys

     3) Place the WIND/X Driver Disk in drive A and close
     the door. Copy the files from the GEM directory.

          Example:  C:\GEMAPPS\GEMSYS>COPY A:\GEM\*.*

     4) To ensure that the mouse will work correctly, you
     must run the GEM installation program to reset the
     mouse type.  Do the following:

          4a) Get the original GEM distribution disks and
          put the one labled "SYSTEM MASTER" into drive A.
          Close the door, and goto A by typing "A:".

          4b) Run the installation program by typing
          "GEMSETUP".

          4c) When prompted, choose
               'Change existing configuration',
                    'Continue',
               'Change current setup',
          and then select the  mouse entry.  Reset the mouse
          even if the setup looks correct.

          4d) Answer the rest of the questions, saving the
          new setup.

     5) Run the application as before, by typing GEM.

          Example:  C:\> gem

