
	     Hauppauge Win/TV Software Versione 3.84.12

Per installare l' applicazione Win/TV esegui setup.exe dal menu
File Esegui di Program Manager. Su sistemi Windows 3.0 
necessario prima copiare il file DDEML.DLL dal dischetto di
installazione al direttorio di sistema di Windows (di solito
C:\WINDOWS\SYSTEM).




TROUBLESHOOTING INFORMATION
===========================

Problems loading and saving typically result from incorrect or conflicting
memory settings.

Three common basic problems are...
        *       The Win/TV Memory Base is set incorrectly.
        *       The system is caching or shadowing memory.
        *       The Win/TV Memory Base used is not excluded by your memory manager
                (resulting in a conflict in upper memory). 


Solutions:
        
        Start Win/TV,  click on Configure, then click on  Board.  Then 
	change the memory address to one suitable for your system.  Exit Win/TV.
	Exit Windows.
        
	Note 1:    When using Win/TV with some VESA Local Bus cards,  the buffer 
	address must be set to D000 or above,  with this region excluded in 
	EMM386.SYS or QEMM386.SYS.  Otherwise saving and loading  images may not
	be possible.   Example: (in config.sys - Always exclude a 32k page frame 
	address.)
	
	If using  B800
	Device = EMM386.EXE X=B800-BFFF

	If using  D000
	Device=EMM386.EXE  X=D000-D7FF 
 
	If using  D800  
	Device=EMM386.EXE  X=D800-DFFF
	
	If using  E000
	Device=EMM386.EXE  X=E000-E7FF

	If using  E800
	Device=EMM386.EXE  X=E800-EFFF

	Reboot machine.....

	Note 2:  Problems may occur while capturing images if your PC tries to 
	shadow the Win/TV buffer.  This occurs often in Pentium systems.  If your
	PC does this, to properly save an image the Memory Base address must be
	uncached or the shadow disabled.  This can be done in your PC's BIOS 
	advanced setup program.  For Example on Gateway2000 Pentium computers with
	the Phoenix Bios do the following (hopefully your computer system has a 
	similar bios configuration):

	1) Go into the setup (hit f1 during boot or post).
	2) Go to menu that says - Disable shadow memory base.  
           Disable shadow memory size.
	3) Set base to selected buffer i.e. D000.
	4) Set size to 32k.
	5) reboot machine

	How to setup a non cacheable block on the Intel Pentium 90 MB with the 
	AMI Bios.

	1) Enter the setup program by hitting F1 on the post.
	2) Use the right arrow key and highlight the ADVANCE menu item - press enter.
	3) Use the down arrow key and highlight PLUG and PLAY - press enter.
	4) Use the down arrow key and highlight ISA SHARED MEMORY SIZE - press enter.
	5) Use the down arrow key and select 32k - press enter.
	6) Use arrow down key and select ISA SHARED MEMORY BASE ADDRESS - press enter.
	7) Select the desired memory range example D0000h - press enter.
	8) Press f10 ( to save and exit) - press enter.
