EXB-8500 Generic EEimages
The following generic EEimages are helpful in a wide
range of situations.  However, if you need a particular
configuration which is not available here, please contact
Exabyte technical support. 

EEImage     Inquiry     Density    Compression     SCSI enhancements     Comments
85E-0010    EXB-8500    8500       NA              enabled               This is the default eeimage for the 8500
85E-0155    EXB-8500    8500       NA              disabled              This is the generic eeimage w/ scsi enhancements disabled
85E-0044    EXB-8200    8500       NA              enabled               8200 inquiry only
85E-0181    EXB-8200    8200       NA              enabled               8200 inquiry and density
85E-0185    EXB-8500    8500       NA              enabled               No EOM @ BOT (for VMS 6.1) based on 85e-0010
85E-0186    EXB-8500    8500       NA              disabled              No EOM @ BOT (for VMS 6.1) based on 85e-0155
85E-0091    EXB-8500    8500       NA              enabled               scsi 1 type inquiry (for older VAXstation platforms)

-------------------------------------------------------------------------

8500 EEPROM LOG FILE
(created Fri Dec 06 10:50:46 1991)

Standard Mode Select defaults           8500 SCSI-2 Command Set

Buffered Mode - ON                      Test Unit Ready
Logical Block Size - 400h               Rewind
Read Retry Count - 0Bh                  Request Sense (Extended)
Wreite Retry Count - 0Bh                Read Block Limits
Reconnect Threshold - 80h               Read
Max Burst Size - 0                      Write
Write Delay Time - 0                    Write Filemarks
Report Early Warning - NO               Inquiry
Cartridge Type - P6                     Space
No Disconnect During Data xfer          Mode Select
          -Disconnects Allowed              
Even Byte Disconnect - ON               Reserve Unit 
SCSI Bus Parity Checking - ON           Release Unit
No Autoload Cartridge - Autoload        Erase
Motion Threshold - 80h                  Mode Sense
Gap Threshold - 7h                      Load/Unload
                                        Receive Diagnostic Results
                                        Send diagnostics
                                        Prevent/Allow Medium Removal
                                        Verify
                                        Locate
                                        Read Position


EEPROM     Create    
Identity   Date       E-number    Description
------------------------------------------------------
82BANXR0   11-22-91   85E-0091    8200 SCSI I Command set         
                                  Busy


85QANXP2   03-01-91    85E-0044   85QANXR0 with Inquiry Data Product ID
                                     set to "EXB-8200 "
                                  This was 85PROD82 and is now 85QANXP2

85QANXR0   01-07-91    85E-0010   Standard Mode Select defaults *
                                  Standard Custom Features **
                                  Standard Inquiry Data ***
                                  8500 (SCSI-2) command set
                                  Queue commands when not ready
                                  P5 cartridge type


85QANXRC   04-15-93    85E-0155   Disable fast SCSI options
                                  Compared with: [8500 SCSI-2]
                                  Data transfer save data ptrs: All data
                                  Immediate discon on any CDB? NO
                                  Slow down status and command complete? YES
                                  Subproduct ID: 85QANXRC

85BANXR8   04-14-94    85E-0181   8200, SUB ID BLANK, DIR SUPPORT W/FILE MARKS
                                  Compared with: [8500 C]
                                  8200 mode is: ON
                                  Even byte disconnect: OFF
                                  Write CRCs on tape? NO
                                  Write compressed tape format? NO
                                  Write compression (DCE): OFF
                                  Raw read: Never
                                  Queueing option: Send busy status
                                  Allow position past EOD? YES
                                  Density code 00 converts to: 15 (90)
                                  Allow filemarks in directory? YES
                                  Immediate WFM command: ILLEGAL
                                  Verify command: ILLEGAL
                                  Space command: 8200
                                  Mode select/sense commands: SCSI-I
                                  Load/Unload command: 8200
                                  Erase command: 8200
                                  Receive Diagnostics command: 8200
                                  Send Diagnostics command: 8200
                                  Locate command: ILLEGAL
                                  Read Position command: ILLEGAL
                                  Default density reporting code: Normal
                                  Returned subproduct id: BLANKS
                                  Inquiry form: 8200
                                  Request sense form: 8200
                                  Product ID: EXB-8200
                                  Subproduct ID: 85BANXR8

85QANXRQ   08-16-94    85E-0185   NO EOM AT BOT, BUILT FROM 85E-0010
                                  Compared with: [8500 SCSI-2]
                                  Always set EOM at BOT? NO
                                  Subproduct ID: 85QANXRQ

85QANXRR   08-25-94    85E-0186   NO EOM AT BOT, SCSI ENHANCEMENTS DISABLED
                                  Compared with: [8500 SCSI-2]
                                  Always set EOM at BOT? NO
                                  Data transfer save data ptrs: All data
                                  Immediate discon on any CDB? NO
                                  Slow down status and command complete? YES
                                  Subproduct ID: 85QANXRR

