
                                 FastCom 1.0
                                 ===========

                        Copyright (c) 2000 Erik Salaj

Description
===========

FastCom requires PC87309 Super I/O chip on motheboard. Using FastCom
you can set communication baud rate up to 1.5 Mbaud. When FastCom
is enabled, baud rate is selectable with this utility only and will
be not affected by applications.

FastCom uses these I/O addresses:

  PC87309  $2E-$2F
  COM1     $3F8-$3FF
  COM2     $2F8-$2FF

Installation
============

1. Windows NT/2000 only: copy IOPORT.SYS driver into WINNT/SYSTEM32/DRIVERS directory
2. Copy FastCom.CPL into Windows SYSTEM (resp. SYSTEM32 on NT/2000) directory
3. Click Control Panel/FastCom and set communication parameters

Ordering
========

The trial version of FastCom is free but supports only baud rates
up to 230400 baud. It also shows dialog box with registering informations.

Unlimited version you receive by E-mail after registration and payment.
Go to http://www.cybermagic.co.nz/winsoft for actual price and registering
informations.

After registration you get free upgrades for a year.

Contact info
============

Erik Salaj
winsoft@napri.sk

http://www.cybermagic.co.nz/winsoft

DISCLAIMER OF WARRANTY
======================

SOFTWARE IS SUPPLIED "AS IS" WITHOUT WARRANTY OF ANY KIND. THE AUTHOR
DISCLAIMS ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION,
THE WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR ANY PURPOSE. THE AUTHOR
ASSUMES NO LIABILITY FOR DAMAGES, DIRECT OR CONSEQUENTIAL, WHICH MAY RESULT
FROM THE USE OF SOFTWARE.