      WAYS TO MAKE A DEAD MAP RUN

  If a level you downloaded does not want to run, here's some ways
to get it going. (Also good if your Quake II game is mildly currupt.)
=====================
[MEHOD 1] (Easiest, and most reliable):

  Start a DEATHMATCH game. Select START A SERVER, and then hit BEGIN
on the next screen. BASE1 will load. Once loaded, bring the console
down and enter:

map mapname

Note that "mapname" is the name of the .BSP file (the map). Leave the
.BSP extension off though.
---
  The level will pop up (if deathmatch is supported. READ DOCS THAT COME
WITH THE LEVELS!). Now start up a REGULAR game. Once a regular game starts,
bring the console down and type in

map mapname

The map will now run.
---
  If using a saved game (loading a game), do the deathmatch part, then load
the game as usual.
======================
[METHOD 2]

   Put game in WINDOWED mode (ALT+ENTER), or use ALT+TAB to minimize your
dead Q2 game. hit CTRL+ALT+DEL and do an END TASK on Quake2. Sometimes,
instead of actually ending the game, the dead map will start running.
======================
[METHOD 3]

   Run TWO Quake II games. Start the map as usual on your first Quake II, when it dies, either do
the ALT+ENTER or ALT+TAB routine. Start another Quake II game and the other
game will start playing the map. If not, continue as usual.
======================
[METHOD 4]

   If it fails, quit the game and try again.



This should help you get any dead maps on your hard drive up and running!
This doc was typed up becuase REoL TOUGH:Prison didn't run, only to find
Quake II was currupt. Hope this helps!

King REoL

