=========================================================================
                    THE BOT JOHNNY (c) 1998 Semprini
                 VIKING CONFIGURATION FILE Version 2.00
                                 By bod
                        bod@designworx.demon.co.uk
                   http://www.designworx.demon.co.uk/
=========================================================================
                        http://jb.quake2.co.uk/
                          semprini@buttle.com
=========================================================================
                              README FILE
=========================================================================


---INTRODUCTION

This is a fairly early release of the Viking Configuration Files.  There
are a number of minor issues and a few bits and pieces here and there.
It is fairly likely that a new version will be available at some point.
Please read the "current issues" section below for information.  This is
vital in particular if you want to use the maps cycle list.


---INSTALLATION

You must have BotJohnny version 2.00 to use these files.  Then:

1. Go to your BotJohnny main folder

2. Unzip the configuration files with "use folder names" checked

3. Run BotJohnny as normal.

4. Set up a new profile using "Viking"

5. IF Viking is installed in a folder called "Viking" you don't need to do
   anything else.  Otherwise go to the PATHS tab.  Click "Change Bot Folder"
   and type in the name of the folder here.


---CURRENT ISSUES

x  VERY IMPORTANT - the Viking map cycle works slightly differently to normal
   in that it is divided up into different sub-lists.  Each sub-list must be
   prefixed by its name.
   
   By default, when you add a new Viking profile, BotJohnny will put
   ":BJ Map Cycle" at the start of your maps list.  DO NOT REMOVE THIS LINE.
   Lines beginning with a colon start a new maps list and give its name.
   
   You must have at least one list name in your map cycle.

x  When using BJ to select your own CTF team, you end up entering the game
   without any statusbar/hud - type 'hud' at the console to bring it back.

x  The grapple var accepts values from 0 to 3, this config only allows you to
   select 0 or 3 - off or 'swing' which is the default.  You can change this by
   right clicking the "grapple" option in the extra options list, choosing EDIT
   and then changing the checked value from "3" to something else.


---REVISION HISTORY

(Note some changes will be obviously in-line with the development of the
program itself.  This list only shows a small selection of bits specific
to Viking)

VERSION 2.00

x  Options converted to BJ2.00 format
x  New "Folder to Store Log File" option - allows you to create a fraglog
   file anywhere on your hard disk


VERSION 1.52

x  Readme stored in config file directly rather than fudged from the program.


VERSION 1.51

x  Time limit, frag limit etc. should now be set properly.  This was my fault,
   not bod's.
x  Viewable weapons option added
x  You can now view the Viking readme
x  New Quake2 options added



---CREDITS

These configuration files were written by bod
This text file was written by Semprini

For bod's home page, see http://www.designworx.demon.co.uk/
For information on BotJohnny, see http://jb.quake2.co.uk
For information on Viking, see http://www.planetquake.com/viking
For information on the Eraser bot, see http://impact.frag.com/

NOTE - if you have any problems with this file, please report tham
to semprini@buttle.com
