
*********** FIX FOR IBM OS/2 WARP 3.0 CSD LEVEL XR03000 ***********

                              IMPORTANT

    PLEASE READ THE FOLLOWING TERMS AND CONDITIONS. DOWNLOADING
    THE SERVICE FIX THAT FOLLOWS, INDICATES YOUR ACCEPTANCE OF THE
    FOLLOWING TERMS AND CONDITIONS:

    - YOU MUST BE, AND YOU AGREE THAT YOU ARE, A PRIOR LICENSEE OF OS/2 WARP
      VERSION 3.0
    - YOU MAY MAKE COPIES OF THE OS/2 WARP VERSION 3.0 SERVICE FIX EQUAL TO
      THE NUMBER OF LICENSED COPIES OF OS/2 WARP VERSION 3.0 YOU POSSESS
    - YOU MAY ONLY USE THIS SERVICE FIX FOR MAINTENANCE PURPOSES
    - ALL OTHER TERMS AND CONDITIONS OF YOUR OS/2 WARP VERSION 3.0 LICENSE
      AGREEMENT APPLY TO THIS SERVICE FIX; HOWEVER, THIS DOES NOT EXTEND ANY
      WARRANTY OUTLINED IN SUCH AGREEMENT.


***************************************
OS/2 WARP 3.0 FIX             = AHA164
CORRECTIVE SERVICE LEVEL(CSD) = XR03000
***************************************
BUILD LEVEL BS.737
***************************************
AFFECTED MODULE(s):
***************************************
AHA164X.ADD

APAR(s) FIXED:
-------------
APAR= PJ16074
ADAPTEC 1640 MCA CARD UNDER WARP FAILS TO SEE CDROM

*************************************************************************
Note: Some fixed APARs may NOT be listed above. If you received this
      FixPak through the IBM OS/2 support channel and your requested
      APAR(s) is/are NOT listed, please install this Fix, your
      requested APAR(s) is/are included.
*************************************************************************

To INSTALL this fix perform the following steps :

WARP Already INSTALLED -

From diskette:
*************
1. Insert diskette with the contents of the UNZIPped AHA164.ZIP in drive A

2. Open an OS/2 window or Full Screen

3. [C:\]Enter cd os2\boot; press the enter key

4. [C:\os2\boot]Enter rename aha164x.add *.bak; press the enter key

5. [C:\os2\boot]Enter copy a:aha164x.add; press the enter key

6. Shut down and reboot your system.

From hardfile:
*************
1. Open an OS/2 window or Full Screen

2. [C:\]Enter cd os2\boot; press the enter key

3. [C:\os2\boot]Enter rename aha164x.add *.bak; press the enter key

4. [C:\os2\boot]Enter copy d:\aha164x.add; press the enter key

   Where d:\ is the drive\path where the file AHA164x.add is located
   on your hardfile which is in the AHA164.ZIP file and seen after you
   UNZIP that file.

5. Shut down and reboot your system.

WARP not Installed --

You must place the AHA164X.ADD file on the INSTALL #1 Diskette

1. Open an OS/2 window or Full Screen

2. Insert the Install Diskette #1 in A:.

4. [A:]Enter rename aha164x.add *.bak; press the enter key

5. [A:]Enter copy d:aha164x.add a:aha164x.add; press the enter key

   Where d:\ is the drive\path where the file AHA164x.add is located
   on your hardfile which is in the AHA164.ZIP file and seen after you
   UNZIP that file.

6. Reboot your system and start the install.
